HP Pro Tablet 608 G1 Maintenance And Service Manual page 44

10. Remove the vibration motor board (see
11. Remove the front-facing webcamera (see
12. Remove the rear-facing webcamera (see
13. Remove the system board (see
14. Remove the right speaker (see
15. Remove the battery and middle plate (see
Remove the outer ring:
1. Remove the power and volume buttons from the ring, and then remove the two 2 mm P0 Phillips screws
(1) that secure the outer ring to the display panel assembly.
2. Disconnect the outer ring from the clips (2) on the frame, and then lift the outer ring from the display
assembly.
Reverse this procedure to install the outer ring.
38 Chapter 5 Removal and replacement procedures
Vibration motor board on page
Front-facing webcamera on page
Rear-facing webcamera on page
System board on page 28).
Right speaker on page 34).
Battery and middle plate on page
24).
25).
26).
35).