HP Pro Tablet 608 G1 Maintenance And Service Manual page 42

8. Remove the WWAN module (see
9. Remove the left speaker (see
10. Remove the audio board (see
11. Remove the vibration motor board (see
12. Remove the front-facing webcamera (see
13. Remove the rear-facing webcamera (see
14. Remove the system board (see
15. Remove the right speaker (see
WARNING!
battery provided by HP, or a compatible battery purchased from HP.
WARNING!
product, use extreme care not to puncture, twist, or crack the battery. A puncture or rupture of the battery
internally can cause a short with the battery bursting into flames.
CAUTION:
prevent loss of information, save your work or shut down the tablet through the operating system before
disconnecting and removing the battery.
Remove the battery and middle plate:
1. Peel off and remove the proximity sensor plastic (1).
2. Remove the six 2 mm P0 Phillips and two 3 mm P0 Phillips screws (1) that secure the middle frame to
the display assembly.
36 Chapter 5 Removal and replacement procedures
Left speaker on page
Audio board on page
System board on page
Right speaker on page
To reduce potential safety issues, use only the battery provided with the tablet, a replacement
Do not remove the battery from the middle plate. To avoid personal injury and damage to the
Removing a battery that is the sole power source for the tablet can cause loss of information. To
WWAN module (select models only) on page
21).
22).
Vibration motor board on page
Front-facing webcamera on page
Rear-facing webcamera on page
28).
34).
19).
24).
25).
26).