Table of Contents
Advertisement
3
Adjusting the machine
▶Always turn off the power when mounting a needle.
▶When using clutch motor, be aware that the motor will continue to rotate for a while even after
1) Inserting needle
As can be seen in figure 6, move the needle upper end so that it directly touches the upper side of the stopper hole when the groove
of the needle is facing inward. Then, use the fixing screw to fix the position of the needle.
Stopper hole
Needle groove
2) Removing bobbin
Place the needle ① in the highest position, and then like in
Figure7, open the hook covers ② on the left and right, lift the
bobbin holder ③ to remove the bobbin ④.
If the operator mistakenly steps on the pedal while the power is on, the machine will start
automatically and can result in physical injuries.
the power is switched off due to inertia.
Start to work on the sewing machine only after the motor has come to a complete stop.
Left and Right
Caution
Clamp screw
③
④
②
Stopper
hole
Needle
Needle
groove
holder
[Figure 6]
①
[Figure 7]
13
Hide quick links:
Advertisement
Table of Contents
