Getting Started; Design And Installation Considerations; Tools And Supplies Required - Outdoor GreatRoom Company Crystal Fire CF-20 User Manual

2
This appliance is a Decorative Gas Appliance for
OUTDOOR USE ONLY and MUST NOT be used
for cooking.
Place the Crystal Fire on a flat and stable surface in
an outdoor location such as a patio or deck. This
location must be adjacent to the gas supply line or
LP gas supply cylinder. DO NOT locate the
appliance where it will get excessively wet or
submerged in water.
A. Design and Installation Considerations
When planning an appliance installation, it's necessary to
determine the following information before installing:
 Where will the appliance be installed? See section 3
 Gas supply piping.
 Framing and finishing details.
B. Tools and Supplies Required
Before beginning the installation, be sure that the
following tools and supplies are at hand.

Gloves

Safety Glasses

Phillips screwdriver

Non-corrosive leak-check solution

Wrenches

1 AAA battery
WARNING
The Outdoor GreatRoom Company
disclaims any responsibility for, and
the warranty will be voided by, the
following actions:

Installation and use of any damaged
components.

Modification of the burner assembly

Installation other than as instructed
by the Outdoor GreatRoom
Company.
Any such action may cause a fire hazard
Page | 6

Getting Started

See section 4
See sections 3,7
www.outdoorrooms.com
WARNING
Asphyxiation Risk
 This gas appliance is for outdoor use in a
well-ventilated space.
 This unit must not be installed inside an
enclosed structure or unvented appliance
WARNING
Do NOT use this appliance if any part of it has
been underwater. Have a qualified service
technician inspect the appliance and replace
any part of the control system and any gas
control which has been underwater.
CAUTION
Sharp Edges
Wear protective gloves and safety glasses
during installation.
WARNING
Do not burn solid fuels in this gas appliance
C. Inspect the Appliance and Components
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.

Do NOT install damaged, incomplete,
or substitute components
Report damaged parts to your dealer.

Carefully remove all burner
components from packaging.

Read all instructions before beginning
installation. Follow these instructions
carefully during installation to ensure
maximum safety and benefit.
Crystal Fire 42435 REV K 12.30.14