Night Light Tm Replacement; Blower Replacement - Napoleon GD80NT Installation And Operating Instructions Manual

46
11.2 NIGHT LIGHT
Your appliance comes equipped with our "Night Light™". The light
has been pre-wired and is controlled from the remote control.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
Unplug the
A.
behind the inner access panel.
Remove the four screws that secure the lens frame.
B.
This frame retains the glass lens. The lamp can now be
accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a clean dry
cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as
lamp and lens are special "high temperature" products. When re-installing, ensure
integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. "Light Leakage" from the upper area may be observed. The
holes in the lamp housing are necessary for ventilation and must not be covered.

11.3 BLOWER REPLACEMENT

Your appliance comes equipped with a heat circulating
blower. The blower is pre-wired and is controlled by the
remote control supplied with the unit. For control details,
see "OPERATION" section.
Drywall dust will penetrate into the blower bearings,
causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the
blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy.
Turn off the power to the appliance.
A.
Turn off the gas valve.
B.
Remove the glass door, logs, rear log support,
C.
side brick panels, rear baffl e, and rear panel.
The mounting plate can now be removed.
D.
Remove the six screws that secure the plate to
the fi rebox back. The blower is secured to this
plate.
Disconnect the wire connectors and ground
E.
before attempting to remove the blower from
the plate.
When re-installing the replacement blower, it
F.
will be necessary to replace the gasket (W290-
0091) on the mounting plate.
W415-0695 / C / 03.19.12
REPLACEMENT
TM
remote receiver from the junction box located
LENSE
FRAME
SCREWS
FIREBOX TOP
GASKET
LENSE
FRAME