Remote Receiver Removal; Valve Removal - Napoleon GD80NT Installation And Operating Instructions Manual

11.4 REMOTE RECEIVER REMOVAL

Open the right control door by pulling bottom portion away from magnet
A.
catch.
Remove the hearth strip by lifting up and away from unit.
B.
Remove the receiver by pulling the left side of the plate away from the
C.
bracket.
Once disengaged pull the wiring harness out from the back of receiver.
D.

11.5 VALVE REMOVAL

The valve on your appliance is piped with two fl ex connectors (one inlet, one
outlet). It can be removed or pulled forward for service.
Remove the hearth strip.
A.
Open the right control door.
B.
Remove the switch plate by pulling on the left side.
C.
Remove the valve housing by pulling on the handle.
D.
Lift up and set the housing towards the back of the appliance.
E.
Remove the wing nut and pivot the valve out from the slot at the
F.
bottom of the valve.
Slowly pull the valve through the control door careful not to kink the gas lines or wires.
G.
Replace all components before returning the appliance to service.
H.
HANDLE
HOUSING
VALVE
RECEIVER
PLATE
SPARK
MODULE
WING NUT
VALVE
SLOT
FAN OUTLET
CONSTANTLY POWERED 120V OUTLET
SPARK MODULE
47
MAINS VOLTAGE
SUPPLY CORD
MODULE ON/OFF SWITCH
COMMUNICATION BUS (3 PIN
120V AUX OUTLET
(4) AA Batteries
HANDLE
HOUSING
VALVE
RECEIVER
PLATE
SPARK
MODULE
W415-0695 / C / 03.19.12