Table of Contents
Advertisement
To Interlock a Group of LanEdge Products on a Desktop
The interlocking feature of the LanEdge products makes it easy for you to
install the units on a desk or table. You can place the units on top of each other
and interlock them to form a stack. A stack can consist of any combination of
LanEdge hubs. It is recommended that the heaviest unit be placed as the base
(bottom) unit. For example, if you are installing a LanEdge FastPrint Server,
place it as the base unit; otherwise, if you are installing a LanEdge
OmniConnect, place it as the base unit.
1. Select the base unit and place it up-side down on a work surface. Locate
the rubber feet and bumpers from the accessory bag. Remove the paper
cover from the adhesive and press a rubber foot into each round receptacle
on the bottom of the unit. Remove the paper cover from the adhesive and
press a rubber bumper into each square receptacle on the bottom of the
unit.
2. Place each of the other units up-side down on a work surface. Locate the
rubber feet and bumpers from the accessory bag. Do not install the square
rubber bumpers. Remove the paper cover from the adhesive and press a
round rubber foot into each round receptacle on the bottom of the unit.
The LanEdge products will not interlock properly if the square rubber
bumpers are installed on the interlocking (upper) unit; install these
bumpers only on the base unit.
3. Place the first LanEdge unit on the desktop as the base. If you are
installing a FastPrint Server, place it as the base (bottom) unit; otherwise,
if you are installing a OmniConnect, place it as the base unit.
FastHub8 and FastHub16 Installation Guide
Note
7
Advertisement
Table of Contents
