Knowing Your Modes; Remote Control Features - MGI Navigator G800 Instruction And Service Manual

18. Knowing your modes

Sureshot mode
•
Displays distances for up to 33 points per hole with sub-metre accuracy
•
Front and carry of up to 15 hazards
•
Front, centre and back of the green
•
Record game statistics including scoring, fairways, putts and longest drive.
•
Upload and save statistics then wirelessly transfer to remote then PC.
Buggy mode
•
Displays the following statistics
•
3 distances - total life, round and shot distance in kilometres or miles
•
2 timers - total life and round time
•
2 battery levels - main and remote control capacities
•
2 speed displays - km/h or mph and selected speed level between 1 and 9
•
Servicing schedule reminders in kilometres (every 500 km)

19. Remote Control features

Charging your remote control - Before you start using your Navigator G800 buggy you must
fully charge the remote control internal lithium ion battery for approximately 6 hours or overnight
with the AC charger. The top right indicator light will flash while charging.
Connect the AC world charger to a suitable power source, using the compatible AC pin plug. Plug
the USB cable from the AC charger into the remote control. The USB connector is located on the
bottom of the remote control. Ensure that the orientation of the plug matches the socket in the
remote control unit.
Turn on the power to the AC adapter. You should allow six hours to fully charge the battery. You
cannot over-charge the battery so you can leave it charging in between use.
You can also charge the remote control using the supplied USB cable and connecting it to a
computer. Note that you should not charge a completely flat battery using this method. You should
use the AC charger. The battery will take longer to charge when using the USB cord.
Forward Arrow - Press to accelerate the buggy. The longer you depress the button, the faster the
buggy travels. Please note: If you wish to regain the speed you were travelling at prior to the last
stop, simply press the forward button twice in succession. The buggy will accelerate to the last
speed setting. This feature works only when you press the stop button to stop the buggy rather
than pressing the down arrow.
Down Arrow - Decreases the speed and provides for reverse. If you are moving forward, the
down arrow can be used to decrease speed, the longer the pressure, the slower the speed. To
operate the Reverse mode you must stop the buggy first. Press the down arrow and the buggy will
reverse. The buggy will move in the backward direction only whilst you keep the down
13