Units Measurements; Distance Modes; Controlled Distance Function [Cdf]; Competition Mode - MGI Hunter Quad User Manual

8.3 Unit Measurements
You can move from kilometres to miles simply by pressing the
Control button 2 [on the right].
8.4

Distance Modes

There are three distance measurements. To move between the
modes by pressing the Control button 1 [on the left]
1. Distance A and B: resettable distance measurements could be
used to measure how far you hit your shot and to measure
how far you have walked for the day. To reset, simply press
the Control button [left side] 1 for 3 seconds until the reading
displays "0".
2. Distance Total: cannot be reset as it is the Odometer for the
life of the buggy. This feature will assist with service reminders
which are recommended at each 500kms or 6 months periods.
8.5

Controlled Distance Function [CDF]

The CDF enables the MGI Quad buggy to be sent a preset
distance before the buggy auto stops. To use this function:
1. It is recommended that you lock the front wheels to ensure the
buggy tracks in a straight line.
2. Press and hold down Speed control button for 3-4 seconds until
the speed setting changes to 10 [5 yards or metres] and the
letter "A" appears
3. Turn the Speed control button clockwise to increase the
distance or anti-clockwise to decrease the distance until the
desired distance is achieved between 10-60 [metres or yards]
4. Always look ahead and assess the condition of the terrain of
where you want to send your buggy prior to doing so
5. Once the desired distance is reached, press the Speed control
button once to send the buggy off to the desired distance.
16
8.6

Competition Mode

In the unlikely event the club you are playing at does not allow
the use of distance devices you will need to disable the distances
feature on the MGI Quad buggy.
To disable the distance recording feature, simply hold down the
two control buttons at the same time for 3 seconds. By doing
this the distance recording will be removed from the screen and
replaced with the words "Comp Mode".
9.0 Integrated GPS Holder
and Compartment
In the top handle compartment is an integrated GPS/mobile
device holder. To open the holder the holder always press the
Coloured button at the top of the holder. Place the GPS into the
cradle, then close the holder by squeezing the two sides closer
together.
MGI Hunter™ Quad User Manual 17