MGI Navigator G800 Instruction And Service Manual page 12

9. Free wheeling
Your buggy uses a gear system, whereby the two rear wheels do not free wheel. The motors
need to be running for the buggy to move. If for some reason your buggy stops operating
during your golf round your buggy can free wheel. Simply depress the quick release tag and
at the same time move the wheel outwords approximately 10mm from its original position. By
doing this, you have disconnected the wheels from the drive and they can rotate freely.
10. Folding/unfolding your buggy
Practice unfolding and folding the buggy using the steps below. This means when you go to
play golf you will be somewhat familiar with this task.
1. Press the red height adjusting button located halfway down the handle [Diagram 1]
2. Lift the handle gently and at the same time turn the lower release button on front
wheel assembly anti-clockwise [Diagram 2]
3. Lift the main handle up completely. Both the top handle and the lower handle will click
into place. Now lift the top bag support up until it clicks into place also
4. The top handle has two positions. Adjust to suit your requirements by pressing the red
height adjusting button
5. Slide seat into the bracket on the right side of the buggy [Diagram 3]
6. Slide sand bucket loop into the bracket on the left side of the buggy. Use the screw to
secure the sand bucket loop [Diagram 4]
MOST IMPORTANT: DEPRESS THE SEAT WITH YOUR HAND BEFORE SITTING.
DO NOT USE THE SEAT ON UNEVEN SURFACES.
*MGI does not warrant any seat support brackets that are damaged or bent.
1
3
9
2
4