Registration; Idle Screen; To Configure Pppoe Via Phone User Interface - Yealink SIP-T23G User Manual

To configure PPPoE via phone user interface:

1. Press Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port.
2. Press
3. Press
4. Enter the user name and password in the corresponding fields.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Note Wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. The SIP-T23P/T23G
IP phone supports up to 3 accounts. If your phone is not registered, you may have to
register it. For more information on how to register your phone, refer to
Management
If the phone has successfully started up, the idle LCD screen will be displayed as below.
The idle screen displays the label of current account, time and date, and four soft keys.
to select IPv4 and then press the Enter soft key.
to select PPPoE IPv4 Client and then press the Enter soft key.
on page 59.
Getting Started
Account
17