To Configure A Static Ipv6 Address Via Phone User Interface - Yealink SIP-T23G User Manual

User Guide for the SIP-T23P/T23G IP Phone
2. Press
3. Press
4. Enter the desired values in the IPv4, Subnet Mask, Default Gateway, IPv4 Pri.DNS
and IPv4 Sec.DNS fields respectively.
5. Press the Save soft key to accept the change or the Back soft key to cancel.

To configure a static IPv6 address via phone user interface:

1. Press Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port.
2. Press
3. Press
4. Enter the desired values in the IPv6 IP, IPv6 IP Prefix, Default Gateway, IPv6 Pri.DNS
and IPv6 Sec.DNS fields respectively.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a PPP negotiation
to obtain the IP address. Contact your system administrator for the PPPoE user name
and password.
16
to select the IPv4 and then press the Enter soft key.
to select Static IPv4 Client and then press the Enter soft key.
to select IPv6 and then press the Enter soft key.
to select Static IPv6 Client and then press the Enter soft key.