Operating Heater - Procom SSU220RHN-GB User Manual

WARNING: Do not allow fans to blow directly into the heater. Avoid any drafts that alter burner flame patterns
including ceiling fans. Altered burner patterns can cause sooting.
WARNING: Do not use a blower insert, heat exchanger insert, or other accessory not approved for use with
this heater.
WARNING: Due to high temperatures, the appliance should be located out of traffic and away from furniture
and draperies.
WARNING: Heater becomes very hot when running. Keep children and adults away from hot surfaces to avoid
burns or clothing ignition. Heater will remain hot for a time after shutoff. Allow surfaces to cool before touching.
WARNING: Do not place clothing or other flammable material on or near the appliance. Never place any ob-
jects in the heater.
WARNING: Carefully supervise young children when they are in the room with the heater.
WARNING: You must operate this heater with the heater door and screen in place. Make sure the heater door
and screen is in place before running heater.
WARNING: Keep the appliance area clear and free from combustible materials, gasoline, and other flammable
vapors and liquids.
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Do not use this appliance with any gas other than the type indicated on the rating plate.
2. Do not place Propane/LP supply tank(s) inside any structure. Store Propane/LP supply tank(s) outdoors.
3. If you smell gas
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
4. Do not install this heater in a bedroom or bathroom.
5. Do not use this heater as a wood-burning heater. Use only the logs provided with the heater.
6. Do not add extra logs or ornaments such as pine cones, vermiculite, or rock wool. Using these added items can
cause sooting. Do not add lava rock around base. Rock and debris could fall into the control area of heater. After
servicing, always replace screen before operating heater.
7. This heater is designed to be smokeless. If logs ever appear to smoke, turn heater off and call a qualified
service person. Note: During initial operation, slight smoking could occur due to log curing and heater burning
manufacturing residues.
8. To prevent the creation of soot, follow the instructions in Care and Maintenance.
9. This heater needs fresh air ventilation to run properly. This heater has an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS shuts down the heater if not enough fresh air is available. See Air for Combus-
tion and Ventilation, pages 6 through 7. If heater keeps shutting off, see Troubleshooting, page 20.
4