Procom SL250TYLA-D Owner's Operation And Installation Manual

Compact lp.& natural gas vent-free stove

Advertisement

OWNER ' S OPERATION AND INSTALLATION MANUAL
SN250TYLA-D

Table of Contents

Safety Information Warning......................................2
Air For Combustion & Ventilation...........................4
Installation..................................................................6
Operating Heater.......................................................9
Cleaning & Maintenance........................................11
Trouble Shooting...................................................12
Specifications..........................................................13
Replacement Parts..................................................14
Parts Breakdown &Parts List.................................17
Installing Blower Accessory...................................20
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may re-
sult causing property damage, personal injury, or
loss of life.
WARNING:
This is an unvented gas-fired
heater. It uses air (oxygen) f r o m t h e r o o m i n
w h i c h i t i s installed. Provisions for adequate
combustion and ventilation air must b e p r o v i d e d .
R e f e r t o A i r F o r Combustion and Ventilation
section on page 4 of this manual.
CINTINENTAL APPLIANCE INC
5 Musick
Irvine
CA 92618
TOLL-FREE NUMBER: 1-877-886-5989
SL250TYLA-D
4600 Highlands Parkway S.E.
SUITE# D/E
Smyrna, GA 30080
COMPACT LP.& NATURAL
GAS VENT-FREE STOVE
Do not store, or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do
not
touch
any
use any phone in your building.
Immediately
call
neighbor's
phone. Follow the gas supplier's
instructions.
If
you
cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
q u a l i f i e d
i n s t a l l e r , s e r v i c e
supplier.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause in-
jury or property damage. Refer to this manual for
correct installation and operational procedures. For
assistance or additional information consult a
qualified installer, service agency, or gas supplier.
This appliance may be installed in an aftermarket*
p e r m a n e n t l y
l o c a t e d ,
(mobile) home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
i n d i c a t e d
o n
t h e
appliance is not convertible for use with other
gases.
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM
HEATERS
Water vaporis a by-product of gas combustion.An unvented
room heater productes approximately one (1) ounce (30ml)
of water for every 1,000 BTU's (.3KW's) of gas input per hour.
Refer to page 6.
Installer:Please leave these instructions with the
consumer
Consumer: Please retain these instructions for future
use.
*Aftermarket: Completion of sale, not for purpose of resale,
from the manufacturer.
electrical
switch; do not
your gas supplier from a
a g e n c y
o r
m a n u f a c t u r e d
r a t i n g
p l a t e . T h i s
g a s

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SL250TYLA-D and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Procom SL250TYLA-D

  • Page 1: Table Of Contents

    OWNER ’ S OPERATION AND INSTALLATION MANUAL SN250TYLA-D SL250TYLA-D Table of Contents Safety Information Warning...2 Air For Combustion & Ventilation...4 Installation...6 Operating Heater...9 Cleaning & Maintenance...11 Trouble Shooting...12 Specifications...13 Replacement Parts...14 Parts Breakdown &Parts List...17 Installing Blower Accessory...20 WARNING: If the information in this manual is...
  • Page 2: Safety Information Warning

    SAFETY INFORMATION WARNINGS I M P O R TA N T: R e a d t h i s owner’s manual carefully and c o m p l e t e l y b e f o r e t r y i n g assemble, operate, or service this...
  • Page 3: Safety Information

    SAFETY INFORMATION Continued 15. Turn off and unplug heater and let cool before servicing. Only a qualified service person should service and repair heater. 16. Operating heater above eleva- tions of 4,500 feet could cause pilot outage. 17. Do not operate heater if any log is broken.
  • Page 4: Providing Adequate Ventilation

    AIR FOR COMBUSTION AND VENTILATION WARNING: This heater shall not be installed in a confined space or unusually tight construc- tion unless provisions are provided for adequate combustion and ven- tilation air. Read the following in- structions to insure proper fresh air for this and other fuel-burning appliances in your home.
  • Page 5 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Gas water heater* Gas furnace Vented gas heater Gas heater logs Other gas appliances* + Total *Do not include direct-vent gas appliances. Direct-vent draws combustion air from the outdoors and vents to the outdoors.
  • Page 6: Installation

    NOTICE: This heater is in- tended for use as supplemental heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, system's circulating blower while using heater.
  • Page 7: Connecting To Gas Supply

    CONNECTING TO GAS SUPPLY WARNING: A qualified service person must connect heater to gas supply. Follow all local codes. CAUTION: Never connect heater directly to the gas supply. This heater requires an external regulator (not supplied). lnstall the external regulator between the heater and gas supply.
  • Page 8: Checking Gas Connections

    CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connections for leaks after install- ing or servicing. Correct all leaks at once. Pressure Testing Gas Supply Piping System Test Pressures In Excess Of 1/2 PSIG(3.5kPa) 1. Disconnect heater with its appliance main gas valve (control valve) and equipment shutoff valve from gas supply piping system.
  • Page 9: Installing Logs

    INSTALLING LOGS WARNING: Failure to position the parts in accordance with these diagrams may result in property dam- age or personal injury. CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HIGH, check to see if flames contact any log.
  • Page 10: Thermostat Control Operation

    THERMOSTAT CONTROL OPERATION The thermostat control knob can be set to any comfort level between HI and LO. The thermostat will gradually modulate the heat output and flame height from higher to lower settings, or pilot, in order to maintain the comfort level you select.
  • Page 11: Cleaning & Maintenance

    CLEANING AND MAINTENANCE CLEANING AND MAINTENANCE WARNING: Turn off heater and let cool before cleaning. CAUTION: You must keep control areas, burner, and circulating air pas- sageways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a qualified service person.
  • Page 12: Troubleshooting

    Note: All troubleshooting items are listed in order of operation. OBSERVED PROBLEM When ignitor button is pressed, there is a spark at ODS/pilot but no ignition. ODS/pilot lights but flame goes out when control knob is released. Burner does not light after ODS/pilot is lit.
  • Page 13: Specifications

    3. Gas regulator is defective. 1. Improper log placement. 2. Air holes at burner inlet are blocked. 3. Burner flame holes are blocked. 1. Metal expanding while heating or contracting while cooling. SPECIFICATIONS SL250TYLA-D 20000/25000 LP Gas Piezo 8"W.C. 14" 11"...
  • Page 14: Replacement Parts

    REPLACEMENT PARTS Note: Use only original replacement parts. This will protect your warranty c o v e r a g e f o r p a r t s r e p l a c e d u n d e r warranty.
  • Page 15 1. Install legs and flex tube. Lay the heater down on its back and remove the regulator dustproof sticker and assemble the gas line into the inlet hole on the regulator. 2. Install the decorating logs. Fasten decorating logs 1 ¡¢ Figure 2 Insert the pinhole on the upper part of log 4 into the pin on the left side of log 1.
  • Page 16 ILLUSTRATED PARTS BREAKDOWN SN250TYLA-D SL250TYLA-D...
  • Page 17: Parts Breakdown &Parts List

    This list contains replaceable parts used in your heater. When PARTS LIST ordering parts, follow the instructions listed under Replacement SN250TYLA-D Parts on page 14 of this manual SL250TYLA-D l n I l n I " 3 " 8...
  • Page 18 ILLUSTRATED PARTS BREAKDOWN SN250TYLA-D SL250TYLA-D...
  • Page 19 PARTS LIST SN250TYLA-D SL250TYLA-D e l f ) t f ) t f l l i r...
  • Page 20: Installing Blower Accessory

    Use two black screws provided in blower kit. Mount blower operation control housing to the bracket at the bottom of stove (see Figure 5). Check to make sure that the power cord is completely clear of blower wheel and there are no foreign objects in blower wheel.
  • Page 21: Side View

    INSTALLING BLOWER ACCESSORY BLOWER ACCESSORY MODEL NFHTX186 Figure 4-A Routing Power Cord Wiring Diagram Decal SIDE VIEW Figure 4-B Routing Power Cord Figure 5 Mounting Control Housing...

This manual is also suitable for:

Sn250tyla-d

Table of Contents