Fisher & Paykel DW60CH Installation Instructions Manual page 48

PROBLEM
White stains are
left on dishes;
glasses have a
milky appearance.
Dishes, cutlery
have not dried.
Glasses have dull
appearance.
Tea stains or
traces of lipstick
have not been
completely
removed.
Traces of rust on
cutlery.
Glasses clouded
and discoloured;
milky coating
Water marks left
on glasses and
cutlery.
46
TROUBLESHOOTING
POSSIBLE CAUSE
Not enough detergent.
Rinse aid dosage too low.
Rinse aid dosage too low.
Items removed too soon.
Rinse aid dispenser empty.
(The rinse aid indicators
are lit.)
Rinse aid dosage too low.
Not enough detergent.
Wash temperature too low.
Cutlery is not sufficiently
rustproof.
Hard water situation.
Glasses are not dishwasher
proof.
Rinse aid level or dosage
setting is too low.
WHAT TO DO
See section 'Wash programmes
and detergent quantities' for
recommended quantities. You may
need to adjust these to suit the
hardness of your water supply.
Increase rinse aid dosage. See 'Using
rinse aid'.
Increase rinse aid dosage. See 'Using
rinse aid'.
After the end of the wash
programme, leave the door ajar and
wait for several minutes to
help drying.
Add rinse aid. See section 'Using
rinse aid' for instructions.
Increase rinse aid dosage. See 'Using
rinse aid'.
See section 'Wash programmes
and detergent quantities' for
recommended quantities. You may
need to adjust these to suit your
particular load.
Select a wash programme with a
higher temperature (see section
'Wash programme data' for
information).
Wash by hand.
Increase detergent quantities.
Wash by hand.
Ensure there is rinse aid in
dispenser. If necessary, increase
the rinse aid setting or try using
a wash programme with a higher
temperature. See sections 'Using
rinse aid' and 'Wash programme
data'.