Fisher & Paykel DW60CH Installation Instructions Manual page 15

Electrical connection
The dishwasher must not be connected to the electrical supply while installation is
● ●
being carried out. Ensure all domestic wiring is properly earthed.
Check the rating label (located on the left-hand side of the dishwasher's stainless steel
● ●
inner door) and ensure that the voltage and frequency values for the current in the
house correspond to those on the rating label.
Insert the plug into a properly earthed power outlet that has a disconnection switch.
● ●
8 DISHWASHER TOPCAP GRAPHICS
IMPORTANT!
The earthing of the appliance is a safety requirement mandated by law.
● ●
If the power cord is not long enough to reach the outlet or the outlet to which the
● ●
appliance must be connected is not appropriate for the plug, the entire dishwasher
power cord must be replaced. This should only be done by a Fisher & Paykel
authorised technician. Do not modify or cut the plug. Do not use an adaptor,
extension cord, or multi-outlet power board to connect the dishwasher to the power
supply, as these could cause overheating and create a fire hazard.
The outlet into which the dishwasher is plugged must remain easily accessible (e.g.
● ●
in an adjacent cabinet) even when the appliance is installed. This is to ensure that
the dishwasher can be disconnected from the power supply for safe cleaning and
maintenance.
Installer final checklist
Check that the door opens and closes freely without resistance to adjacent cabinetry.
● ●
Check that the plug is accessible.
● ●
Check that the dishwasher is level. If necessary, adjust the levelling feet slightly. To
● ●
ensure optimum performance, the dishwasher should not be inclined more than 1
Check with a spirit level.
Check the operation of the dishwasher:
● ●
1 Press
2 Select the Rinse programme.
CH & CHP models: Press
CK models: Press 'Program' button to scroll to 'Rinse'
3 Press
Can you hear the dishwasher filling?
4 When the Rinse programme is over (approx. 20 minutes), check that the water has
drained.
If a fault code appears, see the 'Fault codes' section of the User guide for advice.
INSTALLATION INSTRUCTIONS
to turn the dishwasher on.
until Rinse is selected.
to start the Rinse programme.
.
o
13