Troubleshooting - Fisher & Paykel DW60CH Installation Instructions Manual

FISHER AND PAYKEL P8 DISHWASHER TOPCAP GRAP
DW60CE
PROBLEM
Dishwasher will
not start.
FISHER AND PAYKEL P8 DISHWASHER TOPCAP GRAP
DW60CE
Lower spray
arm rotates with
difficulty.
Cover of
detergent
dispenser cannot
be closed.
Remnants of
detergent stuck
inside dispenser.
Buttons beep and
do not respond.
Water remains
inside dishwasher
after wash has
ended.
Foaming.
44

TROUBLESHOOTING

POSSIBLE CAUSE
No power.
The door is not properly
closed.
Start/Pause button
not been pressed.
Water tap not turned on.
Blocked strainer in water
inlet hose.
Keylock is activated.
Spray arm holes are
blocked by small items or
food particles.
Detergent compartment
has been overfilled.
Detergent dispenser is
clogged with remnants of
detergent.
Compartment was damp
when filled with detergent.
Keylock is activated.
Drain hose is crimped,
bent, or blocked.
Pump is jammed.
Filter(s) blocked.
Incorrect amount or type
of detergent used.
Too much egg in the wash
load.
Rinse aid dosage level too
high.
Rinse aid spills not wiped
up.
WHAT TO DO
Ensure the dishwasher is plugged in
and the power supply is turned on at
the wall.
Close the door.
has Press the Start/Pause button
Ensure water is connected and
turned on.
Check the strainer and clean if
necessary—it is located where the
water inlet hose screws into the tap.
Cancel Keylock by pressing and
holding
goes out.
Clean the spray arm. See 'Care
and cleaning' for instructions.
Remove detergent until the cover
can be closed.
Wipe dispenser out with a damp
cloth. Dry the dispenser before
adding detergent.
Wipe dispenser out with a damp
cloth. Dry the dispenser before
adding detergent.
Cancel Keylock by pressing and
holding
goes out.
Check the drain hose and straighten
if needed.
Call your Fisher & Paykel Authorised
Service Centre or Customer Care.
Clean the filter(s). See 'Care and
cleaning' for instructions.
See section 'Adding detergent' or
consult the detergent manufacturer's
instructions.
Increase the amount of detergent.
Decrease the rinse aid dosage.
Ensure that all rinse aid spills are
wiped up when they occur.
until the keylock indicator
until the keylock indicator
.