DFI G486VPA User Manual page 95

1. Edit the file /etc/conf/pack.d/vth1/space.c to change
the define IRQ number 15 to 11 in the following
way:
2. Relink the kernel by typing:
3. Use the kernel as the boot kernel.
To remove:
Follow the instructions about removing "VIA VESA/
IDE Device Driver" and rebuild the kernel.
Installing the Windows NT 3.1, 3.5 Driver
To install:
The Windows NT driver can be installed using two
methods. The first method is to install the IDE Windows
NT driver at the Windows NT setup time. The second
one is to install the IDE Windows driver after the
system setup. The first method is recommended because
if you do not install the IDE Windows NT driver at the
Windows NT setup time, Windows NT system will not
boot properly. In that case, you should disable the
onboard IDE and plug in a non-enhanced IDE to boot
Windows NT. Install the VT82C496G Windows NT
driver using the second installation method. Then shut
down the system and enable the onboard IDE to boot
Windows NT.
#define WD1_0_VECT 11
# /etc/conf/cf.d/link_unix
IDE Device Drivers u 4-9
G486VPA