DFI G486VPA User Manual page 22

PCI/ISA System Board
Jumper JP4
EPROM Type
Jumper JP4 shoud be set to match the type of the
EPROM installed on the system board. Refer to page
2-9 for the location of the EPROM installed on your
system board.
1 2
1-2 On: 12V Flash
EPROM 28F010
(Default)
Jumper JP16
PS/2 Mouse
The G486VPA package includes a card-edge bracket
with serial and mouse port. The PS/2 mouse port uses
IRQ12. To enable PS/2 mouse, set Jumper JP16 pins 1
and 2 to On. Make sure you connect the PS/2 mouse
port to Connector CN3.
PS/2 Mouse Enabled
PS/2 Mouse Disabled *
* Default setting
2-12 u Installation Overview
3
2-3 On: 5V Flash
EPROM 29F010 or
EPROM 27C010
JP16
1-2 On
2-3 On
1 2 3