DFI G486VPA User Manual page 76

PCI/ISA System Board
If none of the pre-set types is appropriate for your drive,
choose "User", which is the user-definable type. To use
this type, highlight either the drive you want to set:
Primary Master, Primary Slave, Secondary Master or
Secondary Slave. Use the arrow keys until type "User"
is showing. Fill in all the parameters as specified by the
drive manufacturer. If a drive is not installed, select
"None" and press <Enter>.
Drive A and Drive B
These options are used to select the type of floppy disk
drives installed in your system. If either of the drives is
not present, select "None". Make sure you choose the
correct drive type; otherwise, your system might format
the device improperly.
Video
This is used to select the type of video adapter installed
in your system.
Halt on
The system will halt if an error is detected during power
up.
No Errors: The system boot will not stop for any
All Errors: The system will stop whenever the
All, But Keyboard: The system will stop for any
All, But Diskette:
3-4 u Initial Setup Program
detected errors.
BIOS detects a non-fatal error.
errors except a keyboard error.
The system will stop for any
errors except a disk error.