DFI G486VPA User Manual page 91

Installing the NetWare 3.11, 4.0x Driver
To install:
Press <F2> to install the NetWare driver.
The Utility will prompt you to enter the name of direc-
tory for the NetWare driver you want to install. If you
press <Enter>, the driver will be installed under the
default directory.
The NetWare driver can only support the first IDE
channel (VT82C496G). The second IDE channel can be
supported by NetWare ISA disk. To load the ISA disk
and change IRQ value, follow the installation proce-
dures of the NetWare installation manual. The default
IRQ for the second IDE channel is IRQ15.
After the installation, you can type "load" command to
load the driver into NetWare.
Installing the OS/2 2.x, 3.0 Driver
To install:
To find the disk speed, run "VTSETUP.EXE" Utility
under DOS.
After you have executed the speed test, boot the system
from OS/2. Under OS/2 command prompt, type
<DDINSTAL>. For example:
C>DDINSTAL
IDE Device Drivers u 4-5
G486VPA