Table of Contents
Advertisement
Linkage" buttons on right side. Move "Active Frame" to "Policy" button and press
you will enter into "Alarm in Handling" sub menu:
Step 4: Alarm trigger record channel setup
You can select channels to record for each alarm input. In the sub menu, you can use
【
】
【
E NTER
o r
E DIT
Note: In order to trigger the channel to record, in "Recording" menu, you must enable
recording and select record type as "Alarm" or other related type. Please refer to chapter 5.12.
Step 5: Schedule for alarm handle method
When there is external alarm happened in the schedule, DVR will response according to the
handle methods.
Step 6: Alarm handle method
You can select one or more handle method: "On Screen Warning", "Audible Warning",
"Upload to Center" and "Trigger Alarm Output".
Description: If "On Screen Warning" is enabled, when there is external alarm happened and
DVR is in preview mode, DVR will pop-up the related camera. If you trigger more than one
camera, DVR will pop-up them one by one every 10 seconds. When the external alarm is
disappeared, DVR will restore preview mode.
Step 7: Save setup
In "Alarm in Handling" sub menu, press "Confirm" button and return "Alarms" menu. In
"Alarms" menu, press "Confirm" button to save the parameters.
Step 8: PTZ Linkage
Move "Active Frame" to "PTZ Linkage" button, press
Linkage" setup menu:
User Manual of NVR Series DVR
】
k ey to enable record channel. "
P a g e
×
" means disable and " means enable.
【
E NTER
Total
66
104
【
E NTER
】
key,
】
k ey to enter into "PTZ
Advertisement
Table of Contents
