Nitro NVR4SGX User Manual page 57

The whole screen is divided into 22*18 panes (NTSC: 22*15). There is one yellow panel on
the upper left side. The motion area setup steps are the same as that of mask area setup (refer to
chapter 5.7). The only differences are that you can use
area, and mutil motion areas can be defined.
Setup multi areas: After you setup one motion area, press
appear again, then you can setup another motion area.
Clear motion area:
Clear part of motion area: Move the yellow pane to the start clear position of motion area,
【 】
press E DIT , you will find the yellow pane is turned into black pane. You can use
key to enlarge or shrink the black area. Press
【 】
Press E nter k ey to save and return "Image" menu. Press
Clear all motion areas: Press
The kyes used to setup motion areas are following:
【 ↑ 】 【 ↓ 】 【 ← 】 【 → 】
【 E DIT 】 : Yellow panel and red panel switch key:;
【 → 】 : Right enlarge red pane;
【 ← 】 : Left shrink red pane;
【 ↓ 】 : Down enlarge red pane;
【 ↑ 】 : Up shrink red pane;
【 P TZ 】 : Set whole screen as motion area;
【 A 】 : Clear all motion areas;
【 E NTER 】
【 E SC 】 : Cancel setup and return "Image Setup" menu;
The motion detection area is displayed as following:
User Manual of NVR Series DVR
Press
【
【 】
A k ey to clear all motion areas of this channel.
: Move yellow panel to any position;
: Save and return "Image Setup" menu;
P a g e
【 P TZ 】 key to set the whole screen as motion
【 A 】 k ey to clear all motion areas.
【 E DIT
】
E DIT k ey to clear this part motion area.
【
E SC
Total
57 104
】 k ey, the yellow pane will
【 ↓ 】 【 → 】
】
t o cancel.