Specifications - Power Probe III Instruction Manual

Power Probe 3 Specifications
Frequency response of tone pass through
Power Probe Mode – Continuity to ground
First level – display is enabled less than 20K
Second level – green LED is enabled less than 2K
Single event capture less than 200ms pulse width
Repetitive events less than 1ms pulse width
4Hz to over 500Khz Square Wave input
4Hz to over 250Khz Sine Wave input
Threshold for PPAC/Audible passthrough
8 amp thermal response – Manual reset
8 amp 10 amps 15 amps 25 amps Short Circuit
No trip 20 min.
Short
Circuit
25 amps
15 amps
10 amps
8amps
.1 0.3
DC 0 – 70V + 1 digit
P-P 0 – 70V
10Hz to greater than 10 Khz
PP display
15Hz Square Wave
35Hz Sine Wave
– & + Peak Detector Response
Peak to Peak Mode
0 – 70V + 1 digit
Circuit Breaker
Typical Response
6 sec.
2 sec.
16
2 sec. 0.3 sec.
6 sec. 20 min.