Table of Contents
Advertisement
Flow Control – Current Rx Whether pause frames on the port are obeyed
Flow Control – Current Tx Whether pause frames on the port are transmitted
Flow Control – Configured Click to enable flow control for fixed speed settings.
Maximum Frame
Excessive Collision Mode Configure port transmission collision behavior.
Power Control
Save
Reset
Refresh
100Mbps HDX: selects fixed 100Mbps and half duplex
10Mbps FDX: selects fixed 10Mbps and full duplex
10Mbps HDX: selects fixed 10Mbps and half duplex
When "Auto" Speed is selected for a port, this selection indicates the flow control
capability that is advertised to the link partner.
Enter the maximum frame size allowed for the switch port, including FCS.
The allowed range is 1518 bytes to 9600 bytes.
Discard: Discard frame after 16 collisions (default).
Restart: Restart back-off algorithm after 16 collisions.
The column shows the current percentage of the power consumption per port.
The Configured column allows for changing the power savings mode parameters per
port.
Disabled: All power savings mechanisms are disabled.
ActiPHY: Link down power savings is enabled.
PerfectReach: Link up power savings is enabled.
Enabled: Both link up and link down power savings are enabled.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
Click to refresh the page. Any changes made locally will be undone.
-15-
Advertisement
Table of Contents
