Table of Contents
Advertisement
Port State
Auto-refresh
Refresh
3.3.1.3 ACL Status
Configuration
User
Ingress Port
Frame Type
Action
Rate Limiter
Port Copy
possible values.
The current state of the port. Refer to NAS Port State for a description of the
individual states.
Check this box to enable an automatic refresh of the page at regular intervals.
Click to refresh the page; any changes made locally will be undone.
Description
Indicate ACL user.
Indicate the ingress port of the ACE. Possible values are:
Any: The ACE will match any ingress port.
Policy: The ACE will match ingress ports with a specific policy.
Port: The ACE will match a specific ingress port.
Indicate the frame type of the ACE. Possible values are:
Any: The ACE will match any frame type.
EType: The ACE will match Ethernet Type frames. Note that an Ethernet Type based
ACE will not get matched by IP and ARP frames.
ARP: The ACE will match ARP/RARP frames.
IPv4: The ACE will match all IPv4 frames.
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
Indicates the forwarding action of the ACE.
Permit: Frames matching the ACE may be forwarded and learned.
Deny: Frames matching the ACE are dropped.
Indicates the rate limiter number of the ACE. The allowed range is 1 ~ 15. When
"Disabled" is displayed, the rate limiter operation is disabled.
Indicates the port copy operation of the ACE. Frames matching the ACE are copied
to the port number. The allowed values are Disabled or a specific port number.
When Disabled is displayed, the port copy operation is disabled.
-101-
Advertisement
Table of Contents
