Table of Contents
Advertisement
Connect to the console port using a computer with terminal emulation software. See
1
page 31
for details.
Disconnect and reconnect the Switch's power to begin a session. When you reconnect the Switch's
2
power, you will see the initial screen.
When you see the message "Press any key to enter Debug Mode within 3 seconds ..." press
3
any key to enter debug mode.
Type atlc after the "Enter Debug Mode" message.
4
Wait for the "Starting XMODEM upload" message before activating XMODEM upload on your
5
terminal.
After a configuration file upload, type atgo to restart the Switch.
6
Figure 15 Resetting the Switch: Via the Console Port
Bootbase Version: V1.00 | 12/11/2012 13:49:40
RAM: Size = 524288 Kbytes
DRAM POST: Testing: 524288K
OK
DRAM Test SUCCESS !
ZyNOS Version: V4.10(AAGF.5)b1 | 6/5/2014 20:10:8
Press any key to enter debug mode within 3 seconds.
.....................................
Enter Debug Mode
ras> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total
393216 bytes received.
Erasing..
................................................................
OK
ras> atgo
The Switch is now reinitialized with a default configuration file including the default password of
"1234".
4.7 Logging Out of the Web Configurator
Click Logout in a screen to exit the web configurator. You have to log in with your password again
after you log out. This is recommended after you finish a management session for security reasons.
Figure 16 Web Configurator: Logout Screen
Chapter 4 The Web Configurator
XS3700 Series User's Guide
42
Section 3.2 on
Advertisement
Table of Contents
