Table of Contents
Advertisement
NOTE: 4 speed – high extract machines come
equipped with heavier frame construction and
special installation requirements.
Electrical 208-240/60/3, 4 wire with 120 Volt Control
must pass Factory Mutual Systems, CSA, ANSI and
National Electrical Code.
Consult Electrical Code for local requirements.
Manufacturer recommends only three-phase circuit
breakers for three-phase machines.
F232160
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Dimensional Clearances
It is important to allow a minimum of 24 inches at the
rear of the machine and 18 inches at the side for
periodic maintenance, inspection and adjustment. IF
two or more washer-extractors are to be used, they
should be spaced at least 18 inches apart so that
mounting bolts can be tightened properly and walk-
through space for maintenance is available.
NOTE: The dimensions shown here are for planning
purposes only. They are approximate and subject to
normal manufacturing tolerances. If exact dimensions
are required for construction purposes, contact the
distributor or the manufacturer. We reserve the
right to make changes at any time without notice.
A qualified professional engineer should be consulted
to determine local conditions prior to installation.
Installation
9
Advertisement
Table of Contents
