Smtp Email Settings - FLIR M3200 MPX Installation Manual

SMTP EMail Settings

This section describes how to set up SMTP (email) on the DVR to allow Alarm notifications to be sent to I-View Now.

Navigate to the "EMAIL" Setting in
Network

Make sure Enable is checked.

Enter ivnview.com for the SMTP
server

Enter 9116 for the Port

For Sender, Enter the SMTP ID
from the Installer's Worksheet.

For Receiver, Enter the SMTP ID
from the Installer's Worksheet.

Yes, Sender and Receiver are the
same

Change Subject to ALERT

Ensure Enable SSL is chosen

Set Event interval to 0 Minutes

Click "Test" in lower left to verify
connectivity

Click Apply to Save the settings
Test Failure can occur if the SMTP Server, SMTP Port, SSL, DNS, or Firewall settings are incorrect. This Test will not verify
that the Sender and Receiver are correct. It just verifies connectivity to the I-View Now SMTP Server.
Flir M3200/M4200 Series Installation Guide rev 1.0
© 2015 I-View Now, LLC. All Rights Reserved.
Page 7