Upnp Setup; (Non-Upnp) Router Settings - FLIR M3200 MPX Installation Manual

UPnP Setup

If the customer's router supports UPnP – port forwarding can be accomplished automatically.

To check UPnP availability – Choose UPnP in
the Network Menu

Click on "Enable"

In status you will see "Searching Now"

If UPnP is available port mapping details will
be displayed

If UPnP is available and you wish to use it,
click "Apply" to Save your changes.

(Non-UPnP) Router Settings

Router settings must be examined on a case by case basis. I-View Now requires one port to be forwarded to the Device.
This can be done either through port forwarding or NAT (Network Address Translation) depending on what the
installation site's router supports. With either of these router features, any unused/unfiltered External Port can be
forwarded to the TCP Port (also referred to as the video port). The other approach would be to forward external ports to
the DVR using the same External Port and Internal Port. In this case, the ports must be set on the DVR through Network
Settings. Common ports used for forwarding the HTTP port are 1024, 1025, 1026, 1027 or 8080. Common ports used for
forwarding the Video/TCP port are 8010, 8011, 9000, and 9010.
For any of these situations it is the External IP Address and External Port numbers that must be entered into the I-View
Now "Installer's Portal."
Note: Any ports used must be unblocked in any firewall devices (typically just the router).
Flir M3200/M4200 Series Installation Guide rev 1.0
© 2015 I-View Now, LLC. All Rights Reserved.
Page 8