Installation Instructions - Eneo HDC-2080CS D User Manual

FULL-HD MEGA-PIXEL CAMERA

Installation Instructions

Installation and commissioning Instructions
• Make sure the power is removed before the installation.
• Follow the order for applying power.
First connect the low voltage (DC12V or AC24V), then plug the AC adapter
to AC outlets to avoid an improper reset from power jitter and a damage from
the surge voltage when no load.
1. Remove the dust protection cap from the lens mount.
2. Screw the lens onto the camera firmly.
3. Plug the lens plug into the lens connector on the rear of camera case.
4. Mount the camera to the wall or ceilling with a corresponding mounting bracket
through the camera mount holes (1/4" thread insert) on its top or bottom.
CAUTION
• Care should be taken the cable is NOT to be damaged, kinked or exposed in
the hazardous area.
• Do not expose the camera directly to a strong light source such as the sun or
spot light.
Setting the back focus adjustment
The proper back focus adjustment is essential for the motorized zoom lens to
get the all time sharp focus when zooming in and out by the remote control.
For easier and better adjustment, this camera provides FOCUS ASSIST menu
which prevents from the mistake of the focus adjustment.
With enabling FOCUS ASSIST menu, follow the procedure to get the best back
focus adjustment.
1. Set the lens for the zoom position to WIDE and the focus position to INFINITE(∞).
2. Shoot the object departing from about 10Meters.
3. Adjust 'Back focus adjustment with Torque wrench' until the optimum focus
is achieved.
4. Set the lens for zoom position to TELE and adjust the lens focus for best focus.
5. Set the lens for zoom position to WIDE again, check if the focus adjustment
was the best. If not, re-adjust 'Back focus adjustment' slightly.
Start up
When the camera is powered properly, it starts up with initializing the internal
parameters.
09