Part Names; Installation Instructions - Eneo MSM-42F0037MPA Quick Installation Manual

Part names

Bracket
Mounting scew
BH 3x10 mm
OSD Controller
connector
6
Power/Video cable
Video connector
Power connector

Installation instructions

CAUTION: The camera's mounting accessory should be attached
to a structural object, such as concrete, hard wood, wall stud or
ceiling rafter that supports the weight of the camera. If necessary
use appropriate mounting material (e.g. anchors) instead of the
material enclosed with the camera.
• Make sure the power is removed before the installation.
• Follow the order for applying power.
1. Place the camera bracket at the installation position and fix it by using mounting
screws.
2. Connect the power/video cable then setup the camera menu if neccessory. (Use
the mini jig OSD control board)
3. Adjust the camera's viewing angle (Tilt, Rotation)
CAUTION:
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
Camera can be operated with the regulated or unregulated 12VDC but the regulated
power supply of 12VDC is recommended.
Camera is protected from the damage by the reverse connection of polarity.
SDI Output (Yellow)
Power
(
Please use the cable as provided with camera. If camera cable is cut and re-wired,
i
the transmission distance of video can be reduced. Especially SDI cable should not be cut
because it requires detailed wiring job and affects the transmission distance.
Analog Output (Black)
)
EN
7