Setting The Internal Buzzer (For Models With An Internal Buzzer) - Epson TM-T70II Technical Reference Manual

Drawer connection diagram
Control device
Printer side

Setting the Internal Buzzer (for Models with an Internal Buzzer)

Models with the buzzer function can beep the buzzer when the drawer is opened, by setting the
properties of the driver or outputting a pulse signal by a command. The internal buzzer cannot
change the buzzer volume and sound pattern but can change the buzzer frequency. When using
the internal buzzer, you need to enable the internal buzzer with the memory switch.
The buzzer setting is performed by setting the memory switches for the buzzer and specifying
connector pin numbers to which a command outputs a pulse signal, as shown in the table below.
For information about the memory switches, see
Enhancement" on page 54
Memory
Specified connector pin
switch
Buzzer
frequency Drawer kick out connector pin 2
(Pulse 1)
Buzzer
frequency Drawer kick out connector pin 5
(Pulse 2)
Since the buzzer drive signal and the cash drawer drive signal are common in the printer,
do not use the same connector pin numbers to output the signal for the buzzer and the
cash drawer.
 For detailed information about ESC/POS commands, see the ESC/POS Command Ref-
erence.
 For detailed information about the driver control, see the manual for each driver.
Drawer kick-out connector
With shielded
Drawer open/close switch
User side [Drawer kick-out side]
"Setting the Memory Switches/Receipt
ON
Buzzer does not
Buzzer beeps.
Buzzer does not
Buzzer beeps.
Chapter 2 Setup
Drawer kick-out solenoid
OFF Initial setting
OFF
beep.
ON
beep.
69
2