Epson TM-T70II Technical Reference Manual page 89

Setting the memory switch
Follow the steps below to run this mode.
Enter the memory switch setting mode.
1. Check that the roll paper is set and that the printer is turned off.
2. While pressing the Feed button, turn on the printer. Keep pressing the Feed button until the printer
starts printing.
3. When the printer finishes printing the printer status, press the Feed button. Keep pressing the Feed
button until the printer starts printing.
4. Press the Feed button three times.
5. Then press the Feed button. Keep pressing the Feed button until the printer starts printing.
The printer starts printing instructions for settings. Follow the instructions.
Select the setting item
Select the setting item by the number of times the Feed button is pressed as follows.
When the Feed button is not pressed (0 times) or it is pressed more than 12 times, this mode finishes.
❏ 1: Print Current Settings
❏ 2: Print Density
❏ 3: Serial Interface Settings
❏ 4: Automatic Paper Reduction
❏ 5: Auto Paper Feed&Cut at 
cover close
Set the conditions
You can make settings for each condition per setting item by the number of times the Feed button is
pressed.
❏ Print Current Settings
❏ Print Density (page 90)
❏ Serial Interface Settings
❏ Automatic Paper Reduction
❏ Auto Paper Feed&Cut at cover close
❏ Default Character (page
Finish the memory switch setting mode
Turn off the printer. Print out the new settings and save them to the NV memory. Software is reset, and the
printer is ready to print.
❏ 6: Default Character
❏ 7: Embedded Font Replacement
❏ 8: Interface Selection
❏ 9: USB Interface Settings
❏ 10: Printing Speed
❏ 11: Other Settings
❏ Embedded Font Replacement
❏ Interface Selection
❏ USB Interface Settings
(page 90)
❏ Printing Speed
(page 90)
❏ Other Settings
(page 90)
91)
Chapter 3 Application Development Information
When the button is pressed
less than or more than
shown on the left, the set-
ting has not been changed.
(page 91)
(page
(page 92)
(page 92)
(page 91)
91)
89
3