Connecting The Usb Interface Cable - Epson TM-T70II Technical Reference Manual

 Make sure to pull out the power cable before connecting cables.
 When connecting a customer display to the printer, connect the modular jack from the
customer display to the DM-D connector.
 Set the communication conditions of the customer display as follows:
 Baud rate: 19200 bps
 Bit length: 8-bit
 Parity: no parity
 Stop bit: 1

Connecting the USB interface cable

1
Attach the locking wire saddle at the location shown in the figure below.
2
Put the USB cable through the locking wire saddle.
Putting the USB cable through the locking wire saddle, as shown in the figure below,
prevents the cable from coming unplugged.
Locking wire saddle
3
Connect the USB cable from the host computer to the USB upstream
connector.
TM-T70II
USB cable
AC adapter + AC cable
Chapter 2 Setup
Modular cable
DM-D
Modular cable
Cash drawer
USB upstream connector
USB cable
2
49