Setting The Internal Buzzer (For Models With An Internal Buzzer) - Epson TM-T70II Technical Reference Manual

Drawer connection diagram

Setting the Internal Buzzer (for Models with an Internal Buzzer)

Models with the buzzer function can beep the buzzer when the drawer is opened, by setting the properties of
the driver or outputting a pulse signal by a command. The internal buzzer cannot change the buzzer volume
and sound pattern but can change the buzzer frequency. When using the internal buzzer, you need to enable the
internal buzzer with the memory switch.
The buzzer setting is performed by setting the memory switches for the buzzer and specifying connector pin
numbers to which a command outputs a pulse signal, as shown in the table below. For information about the
memory switches, see
Memory
Specified connector pin
switch
Buzzer
frequency Drawer kick connector pin 2
(Pulse 1)
Buzzer
frequency Drawer kick connector pin 5
(Pulse 2)
Since the buzzer drive signal and the cash drawer drive signal are common in the printer, do not
use the same connector pin numbers to output the signal for the buzzer and the cash drawer.
• For detailed information about ESC/POS commands, see the ESC/POS Command Reference.
• For detailed information about the driver control, see the manual for each driver.
46
Control device
Printer side
"Setting the Memory Switches/Receipt Enhancement" on page 32
Drawer kick connector
With shielded
Drawer open/close switch
User side [Drawer kick-out side]
ON
Buzzer does not
Buzzer beeps.
Buzzer does not
Buzzer beeps.
Drawer kick-out solenoid
OFF Initial setting
OFF
beep.
ON
beep.