How To Turn On The Radio And Select A Band, Tuning - Sanyo CDF-R800 Operating Instructions Manual

How to turn on the radio and select a band, Tuning

How to turn on the radio and select a band
1. Press the Radio mode select button ( B) to turn on the radio.
2. Adjust the volume and tone quality. (See page 8 "Audio conrol".)
3. Pressing the Band select button ( m), select the desired band.
With each press, the band shifts as follows.
FM1 +FM2-AM
Tuning . . . . . . . . . . . . . . .
Press the ( 44 ) or ( w ) side of the Tuning button ( . . s EEK. +
To tune up
To tune down
1. Press and hold the ( ti ) or ( w ) side of the Tuning button ( . . s EEKH
onds or more to switch to the manual tuning mode. The frequency indicator will
flash on and off.
It
Note:
returns to Auto (Seek) tuning mode if the Tuning button
seconds after it becomes Manual tuning mode.
2. Press the ( 4+ ) or ( w ) side of the Tuning button ( ..IEEKH ) when the frequency
indicator flashes on and off.
H i n t :
Press and hold the button to change the frequency quickly.
l
There are 2 types as follows.
the next strong station. (The tuning normally operates in
the auto mode.)
Press the ( w ) side for less than 0.7 seconds.
Press the ( + ) side for less than 0.7 seconds.
. . . . . . With each press, the frequency will shift up or down by
50 kHz (FM) or 9 kHz (AM).
Radio mode select button
Band select button
Tuning button
0
is not pressed within 5
0
0
) for 0.7 sec-
1 4