Audiocontrol - Sanyo CDF-R800 Operating Instructions Manual

Audio Control
---Audio control button
Press the ( F\ ) side of the Audio control button to increase, or the ( b ) side to
decrease the volume level. During adjustment, [VOL] appears on the display.
BAS (Bass) I TRE (Treble) / BAL (Balance) / FAD (Fader) control
l
With each press the mode shifts to the next setting. See below.
Note:
Adjust the Bass, Treble, Balance or Fader within 5 seconds after selecting
l
the Audio control mode (the selected mode indicator appears on the display).
If no mode indicator appears on the display, pressing the ( (ii\ ) or ( u)
side of the Audio control button will adjust the volume.
H i n t :
Press and hold the audio control button to change the level quickly.
l
Mode shift
BAS (Bass)
(Fader)
Note:
With each press, the level changes. But the Audio level shown on the display
l
does not change with every press. Use it to know the rough level.
Loudness (LOUD)
l
Press the Loudness button ( g) to emphasize the Bass and Treble range at low
listening level. [LOUD] appears on the display. To cancel the mode, press the but-
ton again.
Loudness button
To decrease
To decrease
To the left speaker
To the rear speaker
To decrease
select the desired mode.
Press F\ .
To increase
To increase
To the right speakers
To the front speakers
To increase
Display
o - 9
o - 9
o - 1 9
8