Radio Operation - Sanyo FXD-770GD Operating Instructions Manual

RADIO OPERATION

54
REL
VOL
TUN
TRK
2
SELECTING RADIO MODE
Press the BAND ATP button 1 to switch from CD mode to the radio mode.
Each time the BAND ATP button is pressed, the selected band changes as shown below.
FM I FM II FM III
RADIO TUNING .................................................................................. 2
• Automatic tuning ............. Press the TUN/TRK
• Manual tuning .................. To select higher frequency station, press the
STORING PRESET STATIONS .......................................................... 3
GB
The preset buttons 3 can be used to store 6 stations in each band (FM 1, FM 2, FM 3 and AM 1, AM 2) for
convenient access to your favorite stations.
• Programming stations .....
E
F
• Quick tuning .................... Select the desired band, then press one of the six preset buttons.
D
FXD-770GD_Ebody(P01-18)
LO/DX FM/AM RECEIVER FXD-770GD 40W X 4
LOUD
PRESET TRACK
CD
L R
FMIII
R F
AMII
LOUD ST LOCBASS MANU TRE
AUD
SHF
3
AM I AM II
When the button is pressed, the system will start automatic tuning and stop at
the next receivable station.
onds. The "MANU" indicator appears in the display window. To select lower
frequency stations, press the
scan up or down in frequency, press and hold the TUN/TRK
Release the button when the display approaches the desired frequency, then
press and release the button repeatedly until the desired frequency is dis-
played. After 4 seconds of completing Manual Tuning, the tuning control will
revert to the Automatic Tuning mode.
1.
Select the desired band, then tune in the station you want to store in memory.
2.
Press and hold one of the preset buttons for more than 2 seconds until the
frequency indicator flashes twice. Repeat steps 1. and 2. to program addi-
tional stations.
8
BAND
ATP
CD
FRONT
SCAN
SHF
RPT
RPT
DISP
PWR
MUTE
or Button 2.
button for more than 0.5 sec-
button for more than 0.5 seconds. To quickly
8
3/7/01, 5:57 PM
1
or button.