Hogtunes NCA 450-AA Installation Manual

Amp for g4 nca 450 u kit

Download this manual

HOGTUNES

Audio Solutions For The Great American Cruiser

NCA 450-AA Amp For

G4 NCA 450 U KIT

Installation Manual

Thank you for choosing the Hogtunes Amplifier Kit for 2014+Rushmore

Platform Bikes. Since positive word of mouth is the best way to grow our

business, we want your new system to work as well as it was designed to.

If you have any questions or concerns, we are here to help. Please call us

at (608)-554-7631 from USA, or (705)-719-6361 from Canada. You can

also email techsupport@hogtunes.com or reach our tech support on the

live chat of our website www.hogtunes.com

Getting Started

Step #1: Remove the seat and both wires (+ and -) from the battery.

Step #2: Remove your outer fairing/headlamp assembly and set aside.

Refer to a service manual if you need help with this. NOTE: Placing a

towel or something similar on the front fender can help prevent "dings" or

scratches from dropped tools or fasteners. Expletives will also be kept to

a minimum!

Step #3: Over top of the radio, pull up to release each wire harness from

the black plate via the factory "Christmas Tree" fasteners. Assuming your

bike has a factory GPS, the small square antenna will need to be

relocated just behind the voltmeter as shown in Fig 1.1. by the white circle

on the next page.

Need help?

Do you have a question about the NCA 450-AA and is the answer not in the manual?

Page 1 G4 NCA 450 U KIT Installation Manual Thank you for choosing the Hogtunes Amplifier Kit for 2014+Rushmore Platform Bikes. Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to.
Page 2 Insta Figure 1.1 - The white circle shows the new location for GPS Antenna if your bike came factory equipped with this feature Step #4: Remove the four factory T-20 “Torx” screws that go through the top of the black plate and into the top of the radio. Set these screws aside for now. The amplifier comes “stuck”...
Page 3 Separate this large factory plug. One plug from the Hogtunes rear harness will plug into each side of the factory plug just separated. They will only go together one way. At this point, all audio connections for this...
Page 4 Step #3: Attach the amp’s red wire to the positive (+) battery terminal and the amp’s black wire to the negative (-) battery terminal. The factory battery wires are also re-installed at this point. When attaching the power and ground wires, it is always a good practice to do the negative first.