To Add A Prefix Or Suffix - Honeywell 5010 User Manual

To Add a Prefix or Suffix:

Step 1. Scan the Add Prefix or Add Suffix symbol
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
Appendix
suffix. For example, for Code 128, Code ID is "j" and Hex ID is "6A".
Step 3. Scan the 2 hex digits from the
cover of this manual or scan 9, 9 for all symbologies.
Step 4. Determine the hex value from the
Page 1252), page A-3, for the prefix or suffix you wish to enter.
Step 5. Scan the 2 digit hex value from the
cover of this manual.
Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7. To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
Note: To add a backslash (\) as in Step 7, you must scan 5C twice – once to
create the leading backslash and then to create the backslash itself.
Step 8. Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Example: Add a Suffix to a specific symbology
To send a CR (carriage return)Suffix for UPC only:
Step 1. Scan Add Suffix.
Step 2. Determine the 2 digit hex value from the Symbology Chart (included in
Appendix
Step 3. Scan 6, 3 from the
manual.
Step 4. Determine the hex value from the
Page 1252), page A-3, for the CR (carriage return).
Step 5. Scan 0, D from the
manual.
Step 6. Scan Save, or scan Discard to exit without saving.
5 - 2
A) for the symbology to which you want to apply the prefix or
A) for UPC.
Programming Chart
Programming Chart
(page
Programming Chart
ASCII Conversion Chart (Code
Programming Chart
inside the back cover of this
ASCII Conversion Chart (Code
inside the back cover of this
5-4).
inside the back
inside the back