Honeywell 5010 User Manual page 16

3. If using an RS-232 connection, connect the serial interface cable to the
engine and to the matching port on the back of the computer.
4. Connect the power supply connector to the serial interface cable. Plug in the
power supply.
5. Turn the terminal/computer power back on. The engine beeps.
6. If connecting the Development Engine using an RS-232 interface, all
communication parameters between the imager and terminal must match for
correct data transfer through the serial port using RS-232 protocol. Scan
the RS-232 interface bar code below. This programs the Development
Engine for an RS-232 interface at 115,200 baud, parity–none, 8 data bits, 1
stop bit, and adds a suffix of a CR LF.
7. Verify the engine operation by scanning a bar code from the
Symbols in the back of this manual. The engine beeps once when a bar
code is successfully decoded.
To connect an 5X10/80 engine to your host system, please refer to the
Integration Manual.
1 - 4
RS-232 Interface
Sample