Chapter 8 - Imaging Commands; Image Snap - Imgsnp; Imgsnp Modifiers - Honeywell 5010 User Manual

8
Imaging Commands
Imaging Commands with their modifiers send imaging commands to the imager
on a single-use basis, and take effect for the next subsequent image capture.
Once that capture is complete, the imager reverts to its imaging default settings.
If you wish to change a default setting, you must use the serial default command
(see Imaging Default Commands
command is used, that selection becomes the new default setting for the imager.

Image Snap - IMGSNP

An image is taken whenever a trigger command is sent, or when the Image Snap
(IMGSNP) command is processed. Image Snap is the command processor for
image capture, or taking a picture.
The image snap command has many different modifiers that can be used to
change the look of the image in memory. Modifiers always begin with numbers
and end with a letter (case insensitive). Any number of modifiers may be
appended to the IMGSNP command. For example, you can use the following
command to snap an image, increase the gain, and have the beeper sound once
the snap is complete:

IMGSNP Modifiers

P - Imaging Style: Sets the Image Snap style.
0P
1P
2P
B - Beeper: Causes a beep to sound after an image is snapped.
0B
1B
E - Exposure: This allows you to set the exposure time. Units are 127
microseconds. For example, an exposure setting of 50 x .127ms = 6.35ms
esposure time. Exposure is used in Manual Style only. (Default = 7874)
n E
IMGSNP2G1B
Decoding Style. This is similar to the current format for decoding,
however, this processing allows a few frames to be taken until the
exposure parameters are met. Then the last frame is available for
further use.
Photo Style (default). This attempts to mimic a simple digital
camera, and results in a visually optimized image.
Manual Style. This is an advanced style, and should not normally
be used. It allows you the most freedom to set up the imager, and
has no auto-exposure.
No beep (default)
Sounds a beep when the image is captured, notifying the user that
the imager can be moved.
Range: 0 - 7874
on page 11-22). When the serial default
8 - 1