Rinse+ Cycle; Activate Rinse+ Cycle; Deactivate Rinse+ Cycle - Electrolux EWM 3000 Service Manual

4.3

Rinse+ cycle

4.3.1

Activate rinse+ cycle

Programming before program start:
- Set selection switch to position ”short spin”.
- Keep ”sensitive” button pressed at least 5 sec.
- To confirm the ”rinse+” LED is flashing for 5 sec.
- While the ”rinse+” LED is flashing, release the ”sensitive” button.
- When the flashing has stopped, the rinse+ cycle is active.
4.3.2

Deactivate rinse+ cycle

Programming before program start:
- Set selection switch to position ”short spin”.
- Keep ”sensitive” button pressed at least 5 sec.
- Immediately when pressing the button, the ”rinse+” LED is flashing.
- After 5 sec the flashing stopps and the LED is lit continuously for 5 sec.
- While the ”rinse+” LED is lit continuously, release the ”sensitive” button.
- After the ”rinse+” LED has stopped lighting, the rinse+ cycle is cancelled.
In order to check whether the rinse+ cycle is activated, set the program selection switch to
”short spin” and press the ”sensitive” button shortly. When the ”rinse+” LED is flashing,
the rinse+ cycle is activated.
An extra rinse cycle increases water consumption and program run time!
DGS-TDS-N 11.2004 C.D.
- 17 -
© Electrolux 599 51 13-50 EN