Additional Programes; Gentle Spin; Spining; Fast Unbalance Control System Fucs - Electrolux EWM 3000 Service Manual

2.

Additional programes

2.1

Gentle spin

Select with program selection switch „gentle spin“
almost same as handlaundry - final spin
2.2

Spining

Select with program selection switch „spining“
almost the same as boiled / colored final spin with 2 pre-spinning phases
2.3

Fast unbalance control system FUCS

Common function:
The FUCS system has 4 phases:
1. Start phase
2. Distribution phase
3. Time out phase
4. Measuring phase
1. Start phase:
In this phase the drumspeed is increased up to 80 1/min.
2. Distribution phase:
During this phase the laundry should be distributed well balanced by regulating the drumspeed.
This phase ends, if 120 1/min are reached or the time of 120s ( at woll 60s ) is expired.
If the time is expired it’s called “Time out (Tout)“.
3. Time out phase:
This phase is excecuted, if the distribution phase has ended in cause of a time out.
This step is neccessary because the drumspeed has to be increased up to 120 1/min.
4. Measuring phase:
During this phase a unbalanced load detection is excecuted like known before.
The spinning cycle is excecuted, depending on the amount of unbalanced load.
An forced acceleration happens if the unbalanced load is to high.
Forced acceleration:
DGS-TDS-N 11.2004 C.D.
Small unbalanced load 1023 1/min
Big unbalanced load 700 1/min
- 6 -
© Electrolux 599 51 13-50 EN