Start - Pause; The Electronic Program-Cycle Display - Electrolux EWM 3000 Service Manual

3.9

Start - Pause

3.10 The electronic program-cycle display

DGS-TDS-N 11.2004 C.D.
- After the program and the options are chosen you start the machine
with the start button.
After that moment you can only change the spinspeed.
- Pause: Program stops in any position.
- During the pausetime the change of the program isn't possible.
- If you turn the selection switch during the program you must restart
the machine.
- indicates the selected program steps
- indicates the actual steps during the program
- indicates the end of program
- indicates at the end of program "Over Dosing", that means too
much detergent is used.
- indicates fault codes
- In the customer service program it also indicates waterlevels
Displayed with LED's or backround illumination
© Electrolux
- 13 -
599 51 13-50 EN