How To Wire Your Ceiling Fan - Emerson CF244BS00 Owner's Manual

BP7408-1 44" & 52" Curva
NOTE: CEILING COVER, SUPPL Y WIRES AND FAN
WIRES OMITTED FOR CLARITY.
Figure 11
WARNING
!
To avoid possible fire or shock, do not
pinch wires between
ball/downrod assembly
bracket.
How to Wire
Your Ceiling Fan
If you feel that you do not have enough
electrical wiring
experience, have your fan installed by a
licensed electrician.
WARNING
!
Turning off wall switch is not sufficient. To
avoid possible electrical shock, be sure
electricity is turned off at the main fuse
box before wiring. All wiring must be in
accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
CAUTION: To reduce the risk of electrical
shock, disconnect the electrical supply
circuit before installing the fan, light kit
or receiver.
NOTE: Make all wiring connections
using wire connectors (supplied). Make
sure that all connections are tight,
including ground, and that no bare wire
is visible at the wire connectors, except
for the ground wire.
8/31/10 3:50 PM Page 9
1. Position the receiver into the ceiling
cover as shown in Figure 12. Place the
antenna wire on top of the receiver.
OUTLET
2. Refer to Figures 12 and 13 to connect
BOX
the receiver wires to the supply wires
and the fan motor wires using the wire
connectors supplied with the fan as
HANGER
BRACKET
follows:
a. Connect the green grounding lead from
HANGER BALL/
DOWNROD ASSEMBLY
the
grounding lead from the hanger bracket
1-1/4" THREADED
to the grounding conductor of supply
STUD (2)
(this may be a bare wire or wire with
green colored insulation). Securely
connect wires with wire connectors
supplied (Figure 12).
b. Securely connect the supply white
the hanger
(neutral) wire to the receiver white
and hanger
(AC IN N)/(TO MOTOR N) wire and
white (neutral) fan wire.
c. Securely connect the supply black wire
to the receiver black/white (AC IN L)
wire.
d. Securely connect the fan motor black
wire to the receiver black (TO MOTOR
knowledge or
L) wire.
e. Securely connect the fan motor blue
wire to the receiver blue (FOR
BOTTOM LIGHT) wire.
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not operate
fan until blades are in place. Noise and
fan damage could result.
9
hanger ball and the
WARNING
!
UL Model No.: CF244 & CF252
green