Wiper Blades - Service Position - Volvo S60 Owner's Manual

10 Maintenance and servicing
||
Lighting Wat-
function tage
Rear fog light 21
10
Backup light 21
Brake light 21
Trunk lighting 10
Front footwell
lighting
NOTE
Please consult a Volvo retailer's Parts
department for the most up-to-date bulb
specifications.
Related information
•
Bulbs – introduction (p. 330)
Not necessary on vehicles with the optional keyless drive.
3
338
Wiper blades – service position
Bulb
The windshield wiper blades must be in the
vertical (service) position for replacement,
H21W LL
washing or to lift them away from the wind-
shield when e.g., removing ice or snow.
H21W LL
P21W LL
SV8.5 (length
38mm)
3 W2, 1x9.5d
type T10
Wiper blades in service position
Be sure the wiper blades are not frozen in
position before attempting to move them
to the service position.
CAUTION
To put the windshiield wipers in the service
position:
1. Insert the remote key into the ignition
3 and press the START/STOP
slot
ENGINE button briefly to put the ignition
in mode I (see Ignition modes (p. 73) for
detailed information about the ignition
modes).
2. Press the START/STOP ENGINE button
again briefly to switch the ignition off.
3. Within 3 seconds, move the right steering
wheel lever up and hold it for at least
1 second.
> The wipers will then move to the verti-
cal (service) position on the windshield.
The wipers can be returned to the normal
position by pressing the START/STOP
ENGINE button briefly to put the ignition in
mode I (or by starting the engine).
CAUTION
If the wiper arms have been folded out
from the windshield while in the service
position, fold them back against the wind-
shield before returning the wipers to the
normal position to help avoid scratching
the paint on the hood.