Volvo S60 Owner's Manual page 172

07 Driver support
||
Before a speed can be set, the cruise control
system must be engaged (put in standby
mode).
– Press the CRUISE button (1).
> The symbol
illuminates and the text
(---) mph
(5) indicates that cruise con-
trol is in standby mode.
NOTE
Putting cruise control in standby mode
does not set a cruising speed.
Setting a speed
Use the or buttons set the vehicle's
current speed. The set speed is shown in the
display.
NOTE
Cruise control cannot be engaged at
speeds below 20 mph (30 km/h).
07
170
Adjusting the set speed
After a speed has been set, it can be
increased or decreased by using the
buttons.
1. Press
or briefly and release the
button to increase or decrease vehicle
speed by approximately 1 mph or 1 km/h.
> This will become the set speed when
the button is released.
2. Press and hold one of these buttons to
increase/decrease the speed in 1-mph or
1-km/h increments. Release the button
when you have reached the desired
speed.
NOTE
•
A temporary increase in speed by
pressing the accelerator pedal, for less
than 1 minute (e.g. when passing
another car), does not affect the cur-
rent cruise control setting. The vehicle
will automatically return to the previ-
ously set speed when the accelerator
pedal is released.
•
If one of the cruise control buttons is
kept depressed for more than approx.
1 minute cruise control is disengaged.
The engine must then be switched off
in order to reset cruise control.
Related information
•
Cruise control (CC) – introduction (p. 169)
•
or
Cruise control (CC) – deactivating
(p. 171)