Bulbs - Headlight Housing - Volvo S60 Owner's Manual

CAUTION
Never touch the glass of bulbs with your
fingers. Grease and oils from your fingers
vaporize in the heat and will leave a
deposit on the reflector, which will damage
it.
WARNING
•
The engine should not be running
when changing bulbs.
•
If the engine has been running just
prior to replacing bulbs in the head-
light housing, please keep in mind that
components in the engine compart-
ment will be hot.
WARNING
•
Active Bending Lights* – due to the
high voltage used by these headlights,
these bulbs should only be replaced
by a trained and qualified Volvo serv-
ice technician.
•
Turn off the lights and remove the
remote key from the ignition before
changing any bulbs.
Related information
•
Bulbs – headlight housing (p. 331)
•
Bulbs – taillight housing (p. 336)
•
Bulbs – vanity mirror lighting (p. 337)
•
Bulbs – license plate lighting (p. 336)
Bulbs – headlight housing
The entire headlight housing must be lifted
out when replacing all front bulbs.
Removing the headlight housing
Pull out the headlight housing's locking
pins.
Remove the headlight housing by alterna-
tively pulling the front and rear edges until
it can be lifted out.
10 Maintenance and servicing
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
Unplug the wiring connector by holding
down the clip with your thumb.
Pull the connector out with the other
hand.
5. Lift out the headlight housing and place it
on a soft surface to avoid scratching the
lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into
place.
*
Option/accessory, for more information, see Introduction.
10
}}
331